Garrett Metal Detectors Sea Hunter Mark II None Manual do Utilizador descarregar pdf (Página 16)

4. Ensure the searchcoil connector at

the rear of the control housing is clean

and the o-ring is well lubricated; add a

little silicon grease or petroleum jelly if

necessary. Do not coat connector pins

with lubricant. Insert coil connector and

gently hand tighten. Do not over tighten.

5. Repeat Step 4 when assembling the

headphone connector at the front of the

control housing.

6. Perform a battery test by switching on

the detector, noting the number of beeps

that occur. Scan a metal object to confirm

detection. If the batteries are low or the

detector fails to operate, verify that the

battery pack and batteries are aligned

properly.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Sem comentários

Garrett Metal Detectors Sea Hunter Mark II None Manual do Utilizador Página 16